Ad
related to: explain diode as a switch circuitzoro.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
An active-low OR diode logic gate is formed by a keypad containing diodes at each switch, all connected to a shared pull-up resistor. When no switch is closed, the pull-up keeps the output high. But when the switch for any key connects to ground, the output goes low. This OR result can be used as an interrupt signal to indicate that any key has ...
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
Various semiconductor diodes. Left: A four-diode bridge rectifier.Next to it is a 1N4148 signal diode.On the far right is a Zener diode.In most diodes, a white or black painted band identifies the cathode into which electrons will flow when the diode is conducting.
The most widely used electronic switch in digital circuits is the metal–oxide–semiconductor field-effect transistor (MOSFET). [2] The analogue switch uses two MOSFET transistors in a transmission gate arrangement as a switch that works much like a relay, with some advantages and several limitations compared to an electromechanical relay.
At high frequencies, the PIN diode appears as a resistor whose resistance is an inverse function of its forward current. Consequently, PIN diode can be used in some variable attenuator designs as amplitude modulators or output leveling circuits. PIN diodes might be used, for example, as the bridge and shunt resistors in a bridged-T attenuator.
The Villard circuit, conceived by Paul Ulrich Villard, [p 1] consists simply of a capacitor and a diode. While it has the great benefit of simplicity, its output has very poor ripple characteristics. Essentially, the circuit is a diode clamp circuit. The capacitor is charged on the negative half cycles to the peak AC voltage (V pk). The output ...
A two-terminal device (e.g., a diode), whose state is completely dependent on the external power circuit to which it is connected. A three-terminal device (e.g., a triode ), whose state is dependent on not only its external power circuit, but also the signal on its driving terminal (this terminal is known as the gate or base ).
The diode remains in conduction until the current through it drops below a value characteristic for the device, called the holding current, I H. Below this threshold, the diode switches back to its high-resistance, non-conducting state. This behavior is bi-directional, meaning typically the same for both directions of current.