Search results
Results From The WOW.Com Content Network
Band-bending diagram for p–n diode in forward bias. Diffusion drives carriers across the junction. Quasi-Fermi levels and carrier densities in forward biased p–n-diode. The figure assumes recombination is confined to the regions where majority carrier concentration is near the bulk values, which is not accurate when recombination-generation ...
The electrons and holes travel in opposite directions, but they also have opposite charges, so the overall current is in the same direction on both sides of the diode, as required. The Shockley diode equation models the forward-bias operational characteristics of a p–n junction outside the avalanche (reverse-biased conducting) region.
Current–voltage characteristic of a p–n junction diode showing three regions: breakdown, reverse biased, forward biased. The exponential's "knee" is at V d. The leveling off region which occurs at larger forward currents is not shown. A diode's current–voltage characteristic can be approximated by four operating regions. From lower to ...
The Shockley diode equation, or the diode law, named after transistor co-inventor William Shockley of Bell Labs, models the exponential current–voltage (I–V) relationship of semiconductor diodes in moderate constant current forward bias or reverse bias:
Forward-biased diodes have low impedance approximating a short circuit with a small voltage drop, while reverse-biased diodes have a very high impedance approximating an open circuit. The diode symbol's arrow shows the forward-biased direction of conventional current flow.
A PN junction in forward bias mode, the depletion width decreases. Both p and n junctions are doped at a 1e15/cm3 doping level, leading to built-in potential of ~0.59V. Observe the different Quasi Fermi levels for conduction band and valence band in n and p regions (red curves). A depletion region forms instantaneously across a p–n junction.
An alternative, which is used for voltage references that need to be highly stable over long periods of time, is to use a Zener diode with a temperature coefficient (TC) of +2 mV/°C (breakdown voltage 6.2–6.3 V) connected in series with a forward-biased silicon diode (or a transistor B–E junction) manufactured on the same chip. [4]
In photovoltaic mode (zero bias), photocurrent flows into the anode through a short circuit to the cathode. If the circuit is opened or has a load impedance, restricting the photocurrent out of the device, a voltage builds up in the direction that forward biases the diode, that is, anode positive with respect to cathode.