Ads
related to: solderless connectors for automotive use
Search results
Results From The WOW.Com Content Network
Crimped connectors are a type of solderless connection, using mechanical friction and uniform deformation to secure a connector to a pre-stripped wire (usually stranded). [1] Crimping is used in splice connectors, crimped multipin plugs and sockets, and crimped coaxial connectors.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
The European versions were equipped with a SAE J1772-2009 inlet as well until the automotive industry settled on the IEC Type 2 “Mennekes” connector as the standard inlet – since all IEC connectors use the same SAE J1772 signaling protocol the car manufacturers are selling cars with either a SAE J1772-2009 inlet or an IEC Type 2 inlet ...
The use of cigarette lighter receptacles to supply 12 volt DC power is an example of backward compatibility to a de facto standard. As a power connector, the lighter receptacle is larger, harder to use and less reliable than other DC connectors [citation needed]. Cigarette lighter receptacles are in widespread use in many highway vehicles and ...
Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.