Ads
related to: cost of steam per kg of gold calculator for water pipe
Search results
Results From The WOW.Com Content Network
Steam can be drawn off as required, either for driving a steam turbine or for process purposes (e.g. in chemical engineering), by opening a steam valve on top of the drum. . The pressure in the drum will fall but the reduced pressure causes more water to boil and the accumulator can go on supplying steam (while gradually reducing pressure and temperature) for some time before it has to be re-char
A compression ratio of 2 is possible (and sometimes more) but unless the motive steam is at a reasonably high pressure (say, 16 bar g - 250 psig - or more), the motive steam consumption will be in the range of 2 kg per kg of suction vapors. A higher compression ratio means a smaller heat exchanger, and a reduced investment cost.
It is followed by caesium, iridium and palladium by mass and iridium, gold and platinum by volume. Carbon in the form of diamond can be more expensive than rhodium. Per-kilogram prices of some synthetic radioisotopes range to trillions of dollars.
The water is heated and then routed into a reduced-pressure flash evaporation "stage" where some of the water flashes into steam. This steam is subsequently condensed into salt-free water. The residual salty liquid from that first stage is introduced into a second flash evaporation stage at a pressure lower than the first stage pressure.
Purified steam relies on a combination of filtration, deionized water, controlled steam generation and a selective membrane process to deliver ultra high purity steam to process. The selective membrane process solves many of the challenges for direct delivery of water vapor by changing the way water molecules are converted from liquid to gas phase.
The specific heat of the human body calculated from the measured values of individual tissues is 2.98 kJ · kg−1 · °C−1. This is 17% lower than the earlier wider used one based on non measured values of 3.47 kJ · kg−1· °C−1.
The heated water/steam mixture then rises into the steam drum. Here, saturated steam is drawn off the top of the drum. In some [which?] services, the steam passes through tubes in the hot gas path, (a superheater) to become superheated. Superheated steam is a dry gas and therefore is typically used to drive turbines, since water droplets can ...
The makeup water in a 500 MWe plant amounts to perhaps 120 US gallons per minute (7.6 L/s) to replace water drawn off from the boiler drums for water purity management, and to also offset the small losses from steam leaks in the system.