When.com Web Search

  1. Ads

    related to: fail open vs close networking exercises examples free download excel workbook

Search results

  1. Results From The WOW.Com Content Network
  2. Ethernet Automatic Protection Switching - Wikipedia

    en.wikipedia.org/wiki/Ethernet_Automatic...

    The next packets sent by the network can then be flooded and learned out of the (now enabled) secondary port without any network disruption. Fail-over times are demonstrably in the region of 50ms. The same switch can belong to multiple domains and thus multiple rings. However, these act as independent entities and can be controlled individually.

  3. Media Redundancy Protocol - Wikipedia

    en.wikipedia.org/wiki/Media_Redundancy_Protocol

    In case of failure, the network works in the Ring-Open status (Figure 2). For instance, in case of failure of a link connecting two MRCs, the MRM sets both of its ring ports to the forwarding state; the MRCs adjacent to the failure each have a disabled port (because of the link loss) and a forwarding ring port; the other MRCs have both ring ...

  4. Ethernet Ring Protection Switching - Wikipedia

    en.wikipedia.org/wiki/Ethernet_Ring_Protection...

    Any failure along the ring triggers a R-APS(SF) (R-APS signal fail) message along both directions from the nodes adjacent to the failed link after these nodes have blocked the port facing the failed link. On obtaining this message, RPL owner unblocks the RPL port. (Note that a single link failure anywhere in the ring ensures a loop free topology.)

  5. Circuit breaker design pattern - Wikipedia

    en.wikipedia.org/wiki/Circuit_breaker_design_pattern

    Half-open state. In this state, the circuit breaker allows a limited number of requests from the service to pass through and invoke the operation. If the requests are successful, then the circuit breaker will go to the closed state. However, if the requests continue to fail, then it goes back to open state.

  6. High-availability Seamless Redundancy - Wikipedia

    en.wikipedia.org/wiki/High-availability_Seamless...

    High-availability Seamless Redundancy (HSR) is a network protocol for Ethernet that provides seamless failover against failure of any single network component. PRP and HSR are independent of the application-protocol and can be used by most Industrial Ethernet protocols in the IEC 61784 suite. HSR does not cover the failure of end nodes, but ...

  7. Common Address Redundancy Protocol - Wikipedia

    en.wikipedia.org/wiki/Common_Address_Redundancy...

    The Common Address Redundancy Protocol or CARP is a computer networking protocol which allows multiple hosts on the same local area network to share a set of IP addresses. Its primary purpose is to provide failover redundancy, especially when used with firewalls and routers. In some configurations, CARP can also provide load balancing ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Delay-tolerant networking - Wikipedia

    en.wikipedia.org/wiki/Delay-tolerant_networking

    Delay-tolerant networking (DTN) is an approach to computer network architecture that seeks to address the technical issues in heterogeneous networks that may lack continuous network connectivity. Examples of such networks are those operating in mobile or extreme terrestrial environments, or planned networks in space.