Search results
Results From The WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
The weight of a rail per length is an important factor in determining rail strength and hence axleloads and speeds. Weights are measured in pounds per yard (imperial units in Canada, the United Kingdom and United States) and kilograms per metre in mainland Europe and Australia). 1 kg/m = 2.0159 lb/yd.
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.
Approximate specific stiffness for various species of wood [53] Material Young's modulus Density (g/cm 3) Young's modulus per density; specific stiffness (10 6 m 2 s −2) Young's modulus per density squared (10 3 m 5 kg −1 s −2) Young's modulus per density cubed (m 8 kg −2 s −2) Applewood or wild apple (Pyrus malus) 8.76715: 0.745: 11. ...
Finger-jointed lumber – solid dimensional lumber lengths typically are limited to lengths of 22 to 24 feet (6.7–7.3 m), but can be made longer by the technique of "finger-jointing" by using small solid pieces, usually 18 to 24 inches (460–610 mm) long, and joining them together using finger joints and glue to produce lengths that can be ...
A felled and delimbed tree is cut into logs of standard sizes, a process called bucking. A logger who specialises in this job is a buck sawyer. Bucking may be done in a variety of ways depending on the logging operation. Trees that have been previously felled and moved to a landing with a log skidder are spread out for processing. While many of ...