Search results
Results From The WOW.Com Content Network
An effects loop is a series of audio effects units, connected between two points of a signal path (the route that a signal would travel from the input to the output); usually between the pre-amp and power amp stages of an amplifier circuit, although occasionally between two pre-amp stages. The two principal uses of effects loops are in ...
Block diagram of the signal-flow for a common feedback loop [1]: 118 . Audio feedback (also known as acoustic feedback, simply as feedback) is a positive feedback situation that may occur when an acoustic path exists between an audio output (for example, a loudspeaker) and its audio input (for example, a microphone or guitar pickup).
A guitar amplifier (or amp) is an electronic device or system that strengthens the electrical signal from a pickup on an electric guitar, bass guitar, or acoustic guitar so that it can produce sound through one or more loudspeakers, which are typically housed in a wooden cabinet.
Guitar feedback effects can be difficult to perform, because it is difficult to determine the sound volume and guitar position relative to a guitar amp's loudspeaker necessary for achieving the desired feedback sound. [112] [113] Guitar feedback effects are used in a number of rock genres, including psychedelic rock, heavy metal music and punk ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
The 20 dB (ten-to-one) feedback loop of the Williamson amplifier wraps around all four stages and the output transformer. According to Richard C. Hitchcock , [ j ] "this is a severe test of design and is one of the outstanding features of the Williamson circuit."
A regenerative circuit is an amplifier circuit that employs positive feedback (also known as regeneration or reaction). [ 1 ] [ 2 ] Some of the output of the amplifying device is applied back to its input to add to the input signal, increasing the amplification. [ 3 ]
The amplifier was reissued for the first time in 1988 (the 1959S), and again from 1991 to 1993 (the 1959X) and from 1993 to 1995 (the 1959SLP). [1] The SLP continued after 1995 but in 2000 Marshall added modifications to lower the noise floor (hum balance pot), reverted the negative feedback resistor to the 1968-69 value of 47 kΩ, and added an effects loop.