Ads
related to: weight of 2x6 lumber per foot table in mm actual thickness formula sheet
Search results
Results From The WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT ...
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
Finger-jointed lumber – solid dimensional lumber lengths typically are limited to lengths of 22 to 24 feet (6.7–7.3 m), but can be made longer by the technique of "finger-jointing" by using small solid pieces, usually 18 to 24 inches (460–610 mm) long, and joining them together using finger joints and glue to produce lengths that can be ...
Fabric "weight" is often specified as mass per unit area, grams per square meter (gsm) or ounces per square yard. It is also sometimes specified in ounces per yard in a standard width for the particular cloth. One gram per square meter equals 0.0295 ounces per square yard; one ounce per square yard equals 33.9 grams per square meter.
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
Lumber refers to smaller dimension or dressed lumber such as 2x4 or 2x6 used in modern construction. Interestingly a sawmill refers to the first machine to cut the lumber, whereas, in modern trade usage, "milled" lumber is further dressed by planing to standard dimensions, or made into molding or specialized forms for cabinet making.
Approximately 2.5 mm is trimmed off the top and bottom faces and 3.8 mm is trimmed off the sides to ensure a flat surface. [13] In some cases, when the lumber edges are not glued because they have an acceptable width tolerance, only the top and bottom faces are planed.