Search results
Results From The WOW.Com Content Network
The generation of a bicylinder Calculating the volume of a bicylinder. A bicylinder generated by two cylinders with radius r has the volume =, and the surface area [1] [6] =.. The upper half of a bicylinder is the square case of a domical vault, a dome-shaped solid based on any convex polygon whose cross-sections are similar copies of the polygon, and analogous formulas calculating the volume ...
A Marsh funnel is a Marsh cone with a particular orifice and a working volume of 1.5 litres. It consists of a cone 6 inches (152 mm) across and 12 inches in height (305 mm) to the apex of which is fixed a tube 2 inches (50.8 mm) long and 3/16 inch (4.76 mm) internal diameter. A 10-mesh screen is fixed near the top across half the cone. [2]
The area required to calculate the volumetric flow rate is real or imaginary, flat or curved, either as a cross-sectional area or a surface. The vector area is a combination of the magnitude of the area through which the volume passes through, A , and a unit vector normal to the area, n ^ {\displaystyle {\hat {\mathbf {n} }}} .
The cone acts as a conditioning device as well as a differential pressure producer. Upstream requirements are between 0–5 diameters compared to up to 44 diameters for an orifice plate or 22 diameters for a Venturi. Because cone meters are generally of welded construction, it is recommended they are always calibrated prior to service.
Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1] [2] =, where A is the cross-sectional area of the flow, P is the wetted perimeter of the cross-section.
Used mainly to determine the minimum water depth for safe passage of a vessel and to calculate the vessel's displacement (obtained from ship's stability tables) so as to determine the mass of cargo on board. Draft, Air – Air Draft/Draught is the distance from the water line to the highest point on a ship (including antennas) while it is ...
Both the conical plate centrifuge and chamber bowl centrifuge can be used for liquid/liquid and solid/liquid separation. However, the advantage of conical plate centrifuge over chamber bowl centrifuge is that solid discharge is possible in conical plate. The chamber bowl has a high capacity for solids but there is no solid discharge.
In general, a conical surface consists of two congruent unbounded halves joined by the apex. Each half is called a nappe, and is the union of all the rays that start at the apex and pass through a point of some fixed space curve. [2] Sometimes the term "conical surface" is used to mean just one nappe. [3]