When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Ethernet extender - Wikipedia

   en.wikipedia.org/wiki/Ethernet_extender

   An Ethernet extender (also network extender or LAN extender) is any device used to extend an Ethernet or network segment beyond its inherent distance limitation which is approximately 100 metres (330 ft) for most common forms of twisted pair Ethernet. These devices employ a variety of transmission technologies and physical media (wireless ...

3. Wi-Fi over Coax - Wikipedia

   en.wikipedia.org/wiki/Wi-Fi_over_Coax

   Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables. As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point , cabling run, and antenna.

4. Wireless repeater - Wikipedia

   en.wikipedia.org/wiki/Wireless_repeater

   Most wireless repeaters (or range extenders) are purpose-built, but certain wireless routers can be flashed with custom firmware such as DD-WRT to give them a 'range extender' option. A better option for extending wireless coverage is to configure a secondary box as a wireless access point , with a wired connection between a LAN port on this ...

5. Long-range Wi-Fi - Wikipedia

   en.wikipedia.org/wiki/Long-range_Wi-Fi

   Long-range Wi-Fi is used for low-cost, unregulated point-to-point computer network connections, as an alternative to other fixed wireless, cellular networks or satellite Internet access. Wi-Fi networks have a range that's limited by the frequency, transmission power, antenna type, the location they're used in, and the environment. [ 1 ]

6. Ethernet over coax - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_coax

   The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...