Search results
Results From The WOW.Com Content Network
Within the trades rebar is known by a shorthand utilizing the bar diameter as descriptor, such as "four-bar" for bar that is four-eighths (or one-half) of an inch. The cross-sectional area of a bar, as given by πr ², works out to (bar size/9.027)², which is approximated as (bar size/9)² square inches.
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound. The symbol g 0 is used to denote standard gravity in order to avoid confusion with the (upright) g symbol for gram.
The reinforcement is usually, though not necessarily, steel reinforcing bars (known as rebar) and is usually embedded passively in the concrete before the concrete sets. However, post-tensioning is also employed as a technique to reinforce the concrete. In terms of volume used annually, it is one of the most common engineering materials.
The applied reinforcement yield stress is = 500 N/mm². The mass density of the reinforcing bars is 7800 kg/m 3. In the table is the computed brittle material stress. is the optimised amount of reinforcement.
Mam Tor road destroyed by subsidence and shear, near Castleton, Derbyshire.. In engineering, shear strength is the strength of a material or component against the type of yield or structural failure when the material or component fails in shear.
4 Hard drawn steel wire for concrete reinforcement. IS 1566 – 1982 5 Method for Tensile testing of Steel products IS 1608 – 1972 6 Code of practice for bending & fixing of bars for concrete reinforcement IS 2502 - 1963 (I) Pre cast R.C.C. Pipes; 1 Specifications for pre cast concrete pipes. IS 458 – 1988 2 Methods of Tests for concrete pipes.
The required concrete cover depends on several factors, including the environmental conditions to which the structure will be exposed, the size of the reinforcing steel, the concrete strength, and the type of structure being constructed. Generally, larger diameter reinforcement bars require more concrete cover than smaller ones.
The reinforcement in a RC structure, such as a steel bar, has to undergo the same strain or deformation as the surrounding concrete in order to prevent discontinuity, slip or separation of the two materials under load. Maintaining composite action requires transfer of load between the concrete and steel.