When.com Web Search

  1. Ads

    related to: atx 12v motherboard pinout

Search results

  1. Results From The WOW.Com Content Network
  2. ATX - Wikipedia

    en.wikipedia.org/wiki/ATX

    An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

  3. Molex connector - Wikipedia

    en.wikipedia.org/wiki/Molex_connector

    AMP Mate-n-Lok and Molex 8981 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors Molex Mini-Fit Jr. connector as used for ATX power supply. A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic ...

  4. Power supply unit (computer) - Wikipedia

    en.wikipedia.org/wiki/Power_supply_unit_(computer)

    12V only System monitoring (P10): This is a 171822-8 AMP or equivalent connector carrying a supply to the PSU fan and sense returns. [32] ATX12V 4-pin power connector (also called the P4 power connector). A second connector that goes to the motherboard (in addition to the 24-pin ATX motherboard connector) to supply dedicated power for the ...

  5. 16-pin 12VHPWR connector - Wikipedia

    en.wikipedia.org/wiki/16-Pin_12vHPWR_connector

    The connector was replaced by a minor revision called 12V-2x6 (H++), introduced in 2023, [2] [3] which changed the GPU- and PSU-side connectors to ensure that the sense pins only make contact if the power pins are seated properly. The cables and their connectors remained unchanged.

  6. Power good signal - Wikipedia

    en.wikipedia.org/wiki/Power_good_signal

    The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).

  7. Motherboard form factor - Wikipedia

    en.wikipedia.org/wiki/Motherboard_form_factor

    Typically used for server-class type motherboards with dual processors and too much circuitry for a standard E.ATX motherboard. LPX: Western Digital? 229 × 279–330 mm (9 × 11–13 in) Based on a design by Western Digital, it allowed smaller cases than the AT standard, by putting the expansion card slots on a Riser card. Used in slimline ...