Ads
related to: jeep dana 30 axle inner seal installer
Search results
Results From The WOW.Com Content Network
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
Ford versions are driver's side differential drop, reverse-cut gears, and kingpin knuckles up to 1991. The later axles have ball joints. Ford Dana 60 axles mostly feature 35 spline inner axle shafts, but some are 30 spline. Larger brakes and 35 spline outer shafts were made standard in 2005.
The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20. Almost all Dana 18 and Dana 20 input gears are 6-spline; the only exception is the one used with the 10-spline version of the T14 transmission.
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
Jeep uses a variety of four-wheel drive systems on their vehicles.These range from basic part-time systems that require the driver to move a control lever to send power to four wheels, to permanent four-wheel systems that monitor and sense traction needs at all four wheels automatically under all conditions.
The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel