Ads
related to: lt1 intake manifold upgrade
Search results
Results From The WOW.Com Content Network
The LT1 uses a new engine block, cylinder head, timing cover, water pump, intake manifold and accessory brackets. The harmonic damper also does not interchange; it is a unique damper/pulley assembly. Engine mounts and bell housing bolt pattern remain the same, permitting a newer engine to be readily swapped into an older vehicle.
Its maximum performance ratings (as installed in 1996 Corvettes) were 300 hp (224 kW) and 340 lb⋅ft (461 N⋅m), well above the 275 net hp and 255 net hp ratings for the original LT-1 in 1971 and 1972, and the 300 ft lb (est) net torque for 1971 and 280 ft lb net for 1972, but well below the 1970 LT1 gross rating of 360 hp.
General Motors has produced three different engines called LT1: 1970–1972 LT-1 – Chevrolet Generation I Small-Block; 1992–1997 LT1 – GM Generation II Small-Block;
A redesigned cylinder head and manifold for improved air flow. Variable exhaust valve timing (the LW2 engine only had variable intake valve timing) Specially-developed fuel injectors. New pistons with pentroof-style centre-domes and valve eyelets for a higher compression ratio of 12.2:1 (compared to 10.2:1 for the dual fuel engine).
The Cadillac 331 engine featured a "dry" (coolant exited through an assembly attached directly to the cylinder heads), open runner (requiring the use of a tappet valve cover) intake manifold, rear-mounted distributor, and shaft-mounted rockers. Crankshaft end play is carried by the rear bearing on the two GM engines.
The inlet manifold of a reverse-flow cylinder head may be connected to the exhaust by a heat riser to transfer further heat, improving low rpm response and emissions as a result. Costs can be reduced in production engines by casting the inlet and exhaust manifolds as one unit. This also transfers further heat to the inlet eliminating the need ...
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1] The word manifold comes from the Old English word manigfeald (from the Anglo-Saxon manig [many] and feald [repeatedly]) and refers to the multiplying of one (pipe) into many.