When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Razor wire - Wikipedia

   en.wikipedia.org/wiki/Razor_wire

   Barbed tape or razor wire is a mesh of metal strips with sharp edges whose purpose is to prevent trespassing by humans. The term "razor wire", through long usage, has generally been used to describe barbed tape products. Razor wire is much sharper than the standard barbed wire; it is named after its appearance but is not razor sharp. The points ...

3. Hemming and seaming - Wikipedia

   en.wikipedia.org/wiki/Hemming_and_seaming

   Hemming and seaming are two similar metalworking processes in which a sheet metal edge is rolled over onto itself. Hemming is the process in which the edge is rolled flush to itself, while a seam joins the edges of two materials. [1] Hems are commonly used to reinforce an edge, hide burrs and rough edges, and improve appearance. [1]

4. Knife sharpening - Wikipedia

   en.wikipedia.org/wiki/Knife_sharpening

   Edge of a knife after sharpening and stropping. Although this edge is sharp enough to bite a thumbnail, cut paper smoothly, or shave arm hair, the microscope plainly shows an edge which reflects light back into the lens. A truly sharp edge is too thin to reflect significant light.

5. AOL Calendar - You're almost there, but your web browser ...

   calendar.aol.com

   Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:

6. Edge banding - Wikipedia

   en.wikipedia.org/wiki/Edge_banding

   Edge-banding or edge tape can refer to the narrow strip of material being used as the veneer. [2] Edge banding is used to cover the exposed sides of materials such as plywood, particle board, or MDF. This increases durability and gives the appearance of a solid or more valuable material. Common substitutes for edge banding include face frames ...

7. Burr (edge) - Wikipedia

   en.wikipedia.org/wiki/Burr_(edge)

   Metal burr extending beyond the edge of the cut piece, view on the cut face (top) and from the bottom (bottom) A burr is a raised edge or small piece of material that remains attached to a workpiece after a modification process. [1] It is usually an unwanted piece of material and is removed with a deburring tool in a process called deburring.