Search results
Results From The WOW.Com Content Network
A top damper or cap damper is a metal spring door placed at the top of the chimney with a long metal chain that allows one to open and close the damper from the fireplace. A throat damper is a metal plate at the base of the chimney, just above the firebox, that can be opened and closed by a lever, gear, or chain to seal off the fireplace from ...
This damper can switch the electrical power to control additional "slave" dampers, minimizing the electrical load on the damper's control circuitry and power transformer. A zone damper (also known as a Volume Control Damper or VCD) is a specific type of damper used to control the flow of air in an HVAC heating or cooling system. In order to ...
A fireplace may have the following: a foundation, a hearth, a firebox, a mantel, a chimney crane (used in kitchen and laundry fireplaces), a grate, a lintel, a lintel bar, an overmantel, a damper, a smoke chamber, a throat, a flue, and a chimney filter or afterburner.
A less common type of dashpot is an eddy current damper, which uses a large magnet inside a tube constructed of a non-magnetic but conducting material (such as aluminium or copper). Like a common viscous damper, the eddy current damper produces a resistive force proportional to velocity. A common use of the eddy current damper is in balance scales.
The distinction is significant since dampers reduce the vibration amplitude by converting the vibration energy into heat. Absorbers store the energy and return it to the vibration system at the appropriate time. [5] Centrifugal pendulum absorbers like tuned mass absorbers are not part of the force/torque flow.
Fire/smoke dampers are similar to fire dampers in fire resistance rating, and also prevent the spread of smoke inside the ducts. When a rise in temperature occurs, the fire damper closes, usually activated by a thermal element which melts at temperatures higher than ambient but low enough to indicate the presence of a fire, allowing springs to ...
A flue is a duct, pipe, or opening in a chimney for conveying exhaust gases from a fireplace, furnace, water heater, boiler, or generator to the outdoors. Historically the term flue meant the chimney itself. [1] In the United States, they are also known as vents for boilers and as breeching for water heaters and modern furnaces.
A Stockbridge damper is a tuned mass damper used to suppress wind-induced vibrations on slender structures such as overhead power lines, [1] long cantilevered signs [2] and cable-stayed bridges. The dumbbell -shaped device consists of two masses at the ends of a short length of cable or flexible rod, which is clamped at its middle to the main ...