Ads
related to: what is two level paging architecture
Search results
Results From The WOW.Com Content Network
In searching for a mapping, the hash anchor table is used. If no entry exists, a page fault occurs. Otherwise, the entry is found. Depending on the architecture, the entry may be placed in the TLB again and the memory reference is restarted, or the collision chain may be followed until it has been exhausted and a page fault occurs.
For example, if a 2 32 virtual address space is mapped to 4 KiB (2 12 bytes) pages, the number of virtual pages is 2 20 = (2 32 / 2 12). However, if the page size is increased to 32 KiB (2 15 bytes), only 2 17 pages are required. A multi-level paging algorithm can decrease the memory cost of allocating a large page table for each process by ...
The current architecture defines PTEs for describing 4 KB and 64 KB pages, 1 MB sections and 16 MB super-sections; legacy versions also defined a 1 KB tiny page. ARM uses a two-level page table if using 4 KB and 64 KB pages, or just a one-level page table for 1 MB sections and 16 MB sections.
It is also helpful to use large pages in the host page tables to reduce the number of levels (e.g., in x86-64, using 2 MB pages removes one level in the page table). Since memory is typically allocated to virtual machines at coarse granularity, using large pages for guest-physical translation is an obvious optimization, reducing the depth of ...
When pure demand paging is used, pages are loaded only when they are referenced. A program from a memory mapped file begins execution with none of its pages in RAM. As the program commits page faults, the operating system copies the needed pages from a file, e.g., memory-mapped file, paging file, or a swap partition containing the page data ...
In a Harvard architecture or modified Harvard architecture, a separate virtual address space or memory-access hardware may exist for instructions and data. This can lead to distinct TLBs for each access type, an instruction translation lookaside buffer (ITLB) and a data translation lookaside buffer (DTLB).
In protected mode with paging enabled (bit 31, PG, of control register CR0 is set), but without PAE, x86 processors use a two-level page translation scheme. Control register CR3 holds the page-aligned physical address of a single 4 KB long page directory.
Paging also allows for pages to be moved out of primary storage and onto a slower and larger secondary storage, such as a hard disk drive. [40] This allows for more memory to be used than physically available in primary storage. [40] The x86 architecture allows control of pages through two arrays: page directories and page tables. Originally, a ...
Ad
related to: what is two level paging architecture