Ad
related to: difference between wan and lan port on router table diagram
Search results
Results From The WOW.Com Content Network
For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed. If the same style of line was used in a WAN (wide area network) diagram, however, it may indicate a different type of connection.
The WAN PHY operates at a slightly slower data-rate than the local area network (LAN) PHY. The WAN PHY can drive maximum link distances up to 80 km depending on the fiber standard employed. The WAN PHY uses the same 10GBASE-S, 10GBASE-L and 10GBASE-E optical PMDs as the LAN PHYs and is designated as 10GBASE-SW, 10GBASE-LW or 10GBASE-EW.
Ethernet (/ ˈ iː θ ər n ɛ t / EE-thər-net) is a family of wired computer networking technologies commonly used in local area networks (LAN), metropolitan area networks (MAN) and wide area networks (WAN). [1] It was commercially introduced in 1980 and first standardized in 1983 as IEEE 802.3.
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
The textbook definition of a WAN is a computer network spanning regions, countries, or even the world. [3] [4] However, in terms of the application of communication protocols and concepts, it may be best to view WANs as computer networking technologies used to transmit data over long distances, and between different networks.
The routing metric used by RIP counts the number of routers that need to be passed to reach a destination IP network. The hop count 0 denotes a network that is directly connected to the router. 16 hops denote a network that is unreachable, according to the RIP hop limit. [4]
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
A routing protocol specifies how routers communicate with each other to distribute information that enables them to select paths between nodes on a computer network. Routers perform the traffic directing functions on the Internet; data packets are forwarded through the networks of the internet from router to router until they reach their ...