Ads
related to: usb serial converter device manager software free
Search results
Results From The WOW.Com Content Network
A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232 , RS-485 , RS-422 , or TTL-level UART serial data.
This class can be used for industrial equipment such as CNC machinery to allow upgrading from older RS-232 serial controllers and robotics, since they can keep software compatibility. The device attaches to an RS-232 communications line and the operating system on the USB side makes the USB device appear as a traditional RS-232 port.
Recipient: USB software component being addressed 0 = Device 1 = Interface 2 = Endpoint 3 = Other 4–31 (reserved) 5–6: Type: Used with bRequest byte 0 = Standard (supported by all USB devices) 1 = Class (Depends on USB device class) 2 = Vendor 3 (reserved) 7: Direction: 0 = Host to device, or no data transfer (wLength == 0)
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
USB On-The-Go (USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mouse or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the roles ...
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.