Search results
Results From The WOW.Com Content Network
Consider a capacitor of capacitance C, holding a charge +q on one plate and −q on the other. Moving a small element of charge dq from one plate to the other against the potential difference V = q/C requires the work dW: =, where W is the work measured in joules, q is the charge measured in coulombs and C is the capacitance, measured in farads ...
Graphical representation of an inductively coupled Marx generator, based on water capacitors. The blue is the water between the plates, and the balls in the central column are the spark gaps that break over to allow the capacitors to charge in parallel, and discharge rapidly in series. A water capacitor is a device that uses water as its ...
An ideal capacitor is characterized by a constant capacitance C, in farads in the SI system of units, defined as the ratio of the positive or negative charge Q on each conductor to the voltage V between them: [23] = A capacitance of one farad (F) means that one coulomb of charge on each conductor causes a voltage of one volt across the device. [25]
The capacitor C 1 is used to transfer energy. It is connected alternately to the input and to the output of the converter via the commutation of the transistor and the diode (see figures 2 and 3). The two inductors L 1 and L 2 are used to convert respectively the input voltage source (V s) and the output voltage (V o) into current sources. At a ...
[1] Because an electrochemical capacitor is composed out of two electrodes, electric charge in the Helmholtz layer at one electrode is mirrored (with opposite polarity) in the second Helmholtz layer at the second electrode. Therefore, the total capacitance value of a double-layer capacitor is the result of two capacitors connected in series.
positive to negative peak: Voltage of C 1 has dropped to 0 V by the end of the previous step, thus allowing C 3 to be charged through D 3 to 2U s. negative to positive peak: Voltage of C 2 rises to 2U s (analogously to step 2), also charging C 4 to 2U s. The output voltage (the sum of voltages of C 2 and C 4) rises until 4U s is reached.
It is the time required to charge the capacitor, through the resistor, from an initial charge voltage of zero to approximately 63.2% of the value of an applied DC voltage, or to discharge the capacitor through the same resistor to approximately 36.8% of its initial charge voltage.
Figure 1: Stray capacitances are often drawn with dashed lines. This equivalent circuit of part of a Tesla coil has stray capacitance between each winding and one to ground. Parasitic capacitance or stray capacitance is the unavoidable and usually unwanted capacitance that exists between the parts of an electronic component or circuit simply ...