Search results
Results From The WOW.Com Content Network
Cohen's kappa measures the agreement between two raters who each classify N items into C mutually exclusive categories. The definition of is =, where p o is the relative observed agreement among raters, and p e is the hypothetical probability of chance agreement, using the observed data to calculate the probabilities of each observer randomly selecting each category.
Calculate the variance of each component parameter as sensitivity times absolute tolerance; Use at least two methods of analysis (e.g. hand analysis and SPICE or Saber, SPICE and measured data) to assure the result; Generate a formal report to convey the information produced; The design is broken down into the appropriate functional sections.
Failure rate is the frequency with which any system or component fails, expressed in failures per unit of time. It thus depends on the system conditions, time interval, and total number of systems under study. [1]
Reliability engineering is a sub-discipline of systems engineering that emphasizes the ability of equipment to function without failure. Reliability is defined as the probability that a product, system, or service will perform its intended function adequately for a specified period of time, OR will operate in a defined environment without failure. [1]
Reliability index is an attempt to quantitatively assess the reliability of a system using a single numerical value. [1] The set of reliability indices varies depending on the field of engineering, multiple different indices may be used to characterize a single system.
It provides ready linkage between Ergonomics and Process Design, with reliability improvement measures being a direct conclusion which can be drawn from the assessment procedure. It allows cost benefit analyses to be conducted; It is highly flexible and applicable in a wide range of areas which contributes to the popularity of its use [3]
Lusser's law in systems engineering is a prediction of reliability.Named after engineer Robert Lusser, [1] and also known as Lusser's product law or the probability product law of series components, it states that the reliability of a series of components is equal to the product of the individual reliabilities of the components, if their failure modes are known to be statistically independent.
The correlation between scores on the two alternate forms is used to estimate the reliability of the test. This method provides a partial solution to many of the problems inherent in the test-retest reliability method. For example, since the two forms of the test are different, carryover effect is less of a problem. Reactivity effects are also ...