Search results
Results From The WOW.Com Content Network
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
The relationship between gallons per minute (gpm) and fixture unit is not constant, but varies with the number of fixture units. For example, 1000 FU is equivalent to 220 US gallons per minute (0.014 m 3 /s) while 2000 FU represents only 330 US gallons per minute (0.021 m 3 /s), about 1.5 times the flow rate.
The average shower uses 15.8 gallons (59.7 liters) and lasts for 7.7 minutes at average flow rate of 2.1 gallons per minute (gpm) (7.9 liters per minute). [1] On average, in a household of average size (2.65 persons) 12.4 showers are taken each week.
K-Factors have also previously been calculated and published using the United States customary units of pound per square inch (psi) and gallon per minute (gpm). Within the United States, US measurements are still often used instead of metric. [3] [4]
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
For liquids, various units are used depending upon the application and industry, but might include gallons (U.S. or imperial) per minute, liters per second, liters per m 2 per hour, bushels per minute or, when describing river flows, cumecs (cubic meters per second) or acre-feet per day.
Light passenger vehicles pump up to about 50 litres (13 US gallons) per minute [8] (the United States limits this to 10 US gallons [38 litres] per minute [9]); pumps serving trucks and other large vehicles have a higher flow rate, up to 130 litres (34 US gallons) per minute in the UK [8] and 40 US gallons (150 litres) in the US. This flow rate ...
where: [2] Q f = total residual flow during the test (gallons per minute); c = discharge coefficient (unitless). This is usually 1.0 if using a diffuser. If using a wand to measure the stagnation pressure, the coefficient value depends on the shape of the flow hydrant orifice.