Search results
Results From The WOW.Com Content Network
An edge connector is the portion of a printed circuit board (PCB) consisting of traces leading to the edge of the board that are intended to plug into a matching socket. The edge connector is a money-saving device because it only requires a single discrete female connector (the male connector is formed out of the edge of the PCB), and they also ...
The keyboard was part of the main computer PCB, but before assembly, the constructor could opt to cut the keyboard section of the printed circuit board off and connect it to the main board with ribbon cable. The keyboard was wired as an 8 × 8 matrix and connected to the computer via the two 8-bit ports of a Z80 PIO chip.
Not to be confused with Printed electronics. "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the through-hole paths to the other surface, and ...
A riser card inside an IBM PS/2, featuring MCA slots Motherboard of an IBM PS/ValuePoint personal computer model (c. from 1993 to 1995) with an Intel i486SX microprocessor, with an elongated connector (black, horizontally in the middle/left between upper and lower edge) for the riser card on which the ISA bus slots were located
While the Personal Computer/AT has a 16-bit Intel 80286 microprocessor, the Deskpro 386 features Intel's then-cutting-edge 32-bit 80386 processor. The initial three models in the Deskpro 386 line—the Deskpro 386 Model 40, the Deskpro 386 Model 70, and the Deskpro 386 Model 130—differ only in the storage capacity of the included hard disk ...
Four-PCB panel. Depaneling or depanelization is a process step in high-volume electronics assembly production. In order to increase the throughput of printed circuit board (PCB) manufacturing and surface mount (SMT) lines, PCBs are often arranged in a process called panelization so that they consist of many smaller individual PCBs that will be used in the final product.
Overscan is a behaviour in certain television sets in which part of the input picture is cut off by the visible bounds of the screen. It exists because cathode-ray tube (CRT) television sets from the 1930s to the early 2000s were highly variable in how the video image was positioned within the borders of the screen.
The finished photomask was photolithographically reproduced onto a photoresist coating on the blank copper-clad boards. A PCB as a design on a computer (left) and realized as a board assembly populated with components (right). The board is double sided, with through-hole plating, green solder resist and a white legend.