When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. The M. K. Morse Company - Wikipedia

   en.wikipedia.org/wiki/The_M._K._Morse_Company

   In 2001, Morse launched the Master Cobalt line of Reciprocating saw blades. In 2020, Morse launched the Jawbreaker bandsaw blade, designed to cut superalloys and other very hard-to-cut materials. Most band saw blades create the kerf by bending the teeth side to side, which results in premature tooth wear. With this new blade, the kerf is ...

3. Hacksaw - Wikipedia

   en.wikipedia.org/wiki/Hacksaw

   A panel hacksaw An electric hacksaw. A panel hacksaw has a frame made of a deep, thin sheet aligned behind the blade's kerf, so that the saw could cut into panels of sheet metal without the length of cut being restricted by the frame. The frame follows the blade down the kerf into the panel. Junior hacksaws are a small version with a half-size ...

4. Cold metal transfer - Wikipedia

   en.wikipedia.org/wiki/Cold_Metal_Transfer

   Cold metal transfer (CMT) is a welding method that is usually performed by a welding robot. The CMT machine detects a short circuit which sends a signal that retracts the welding filler material, giving the weld time to cool before each drop is placed. This leaves a smooth weld that is stronger than that of a hotter weld.

5. Cold saw - Wikipedia

   en.wikipedia.org/wiki/Cold_saw

   Cold saw blades are used to cut metal using a relatively slow rotational speed, usually less than 5000 surface feet per minute (SFM) (25 m/s), and a high chip load per tooth, usually between .001"–.003" (0.025–0.08 mm) per tooth. These blades are driven by a high power motor and high-torque gear reduction unit or an AC vector drive.

6. Coping saw - Wikipedia

   en.wikipedia.org/wiki/Coping_saw

   A coping saw consists of a thin, hardened steel blade, stretched between the ends of a square, c shaped, springy-iron frame to which a handle is attached. The blade is easily removed from the frame so that the blade can be passed through a drilled hole in the middle of a piece of wood. The frame is then re-attached to the blade and the cut ...

7. Carbide saw - Wikipedia

   en.wikipedia.org/wiki/Carbide_saw

   Due to the thin blade body the blades must be stabilized to minimize the side vibration amplitudes. When the first experiments with carbide saws were made, a development engineer of Advanced Machine & Engineering in Rockford stabilized the blade by using a broomstick which he pushed against the vibrating blade, minimizing the vibrations.