Search results
Results From The WOW.Com Content Network
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."
The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel
Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Dana 50; Dana 53; Dana 60; Dana 70; Dana 80; Dana S 110; F ...
M-series chassis use a Dana 60 or 70 or Spicer M70 solid rear axles with leaf springs. Frames were used by Winnebago , Champion , Apollo MotorHomes and several other RV manufacturers. The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [ 1 ] M-500, and M-600 depending on the application.
The Dana/Spicer Model 44 is an automotive axle manufactured by Dana Holding Corporation and is used extensively among automobile manufacturers and in the automotive aftermarket area as well. The Dana 44 was first manufactured in the 1940s [ 1 ] and is still being manufactured today, both front and rear axle variants.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
The ID number C300-15 is stamped on the case. The output for the front drive shaft is on the right side and the rear output in line with the input. Low range is 2.62:1. One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986.