Ads
related to: boiler blowdown valve high pressure oil pump
Search results
Results From The WOW.Com Content Network
Bottom blowdown involves periodically opening valves in the mud drum to allow boiler pressure to force accumulated sludge out of the boiler. Similar blowdown connections at the bottom of water wall headers are blown down less frequently. [4] Several short blowdown events remove sludge more effectively than a single continuous blowdown.
Hose for conveying force to train brakes by a differential in air pressure. Contains either high-pressure compressed air or air at lower than atmospheric pressure (vacuum), depending on whether the locomotive has an air brake or vacuum brake system. [6]: 483–486 [3]: 1 Water compartment Tank for water to be used by the boiler to produce steam.
Scum valve A blow-down valve mounted at the water-level of a boiler, used to blow down lighter oily or foamy deposits within a boiler that float on the water-level. Sludge another term for mud. Smokebox an enclosed space at the extremity of a fire-tube boiler, where the exhaust gases from the tubes are combined and pass to the flue or chimney.
One consideration is the introduction of feedwater to the boiler. The pump used to charge the boiler must be able to overcome the boiler's operating pressure, else water will not flow. As a superheated boiler is usually operated at high pressure, the corresponding feedwater pressure must be even higher, demanding a more robust pump design.
A blowdown stack is an elevated vent or vertical stack that is used to vent the pressure of components of a chemical, refinery or other plant if there is a process problem or emergency. A blowdown stack can be used to complement a flare stack or as an alternative. The purpose is to prevent 'loss of containment' of volatile liquids and gases.
A safety shutoff valve should be fail-safe, that is close upon failure of any element of the input control system (such as temperature controllers, steam pressure controllers), air pressure, fuel pressure, current from a flame detector, or current from other safety devices such as low water cutoff, and high pressure cutoff. A blowdown valve ...
The HP boiler worked at approx 850 psi (5.86 MPa), and the low-pressure boiler at 200 to 250 psi (1.38 to 1.72 MPa). The UHP and HP boilers were of a water-tube design, while the LP boiler was a fire-tube boiler typical for steam locomotives. The LP cylinders were driven with a mixture of the HP cylinder exhaust and the LP boiler output.
A high-integrity pressure protection system (HIPPS) is a type of safety instrumented system (SIS) designed to prevent over-pressurization of a plant, such as a chemical plant or oil refinery. The HIPPS will shut off the source of the high pressure before the design pressure of the system is exceeded, thus preventing loss of containment through ...