Ads
related to: fujisoku sram memory card pcmcia 10
Search results
Results From The WOW.Com Content Network
When in July 1989, [1] Poqet contacted Fujitsu for their existing but still non-standardized SRAM memory cards, and Intel for their flash technology, [1] the necessity and potential of establishing a worldwide memory card standard became obvious to the parties involved. This led to the foundation of the PCMCIA organization in September 1989. [1 ...
As PC Cards (was PCMCIA), Linear Flash cards should have a Card Information Structure (CIS). However, many memory cards do not have a CIS. However, many memory cards do not have a CIS. Linear Flash cards begin to develop bad blocks after about 100,000 erase/write cycles and thus are of dubious value on the second-hand market.
Before the introduction of the PCMCIA card, the parallel port was commonly used for portable peripherals. [6] The PCMCIA 1.0 card standard was published by the Personal Computer Memory Card International Association in November 1990 and was soon adopted by more than eighty vendors. [7] [8] It corresponds with the Japanese JEIDA memory card 4.0 ...
PCMCIA type 1 slot. The Marty's IC Card slot is compatible with type 1 PCMCIA cards, including battery-backed SRAM cards (accessible from the BIOS menu) that can be mapped to a drive letter and used as a small drive. Fujitsu also officially released a PCMCIA 2400 bit/s modem (FMM-CM301) for the FM Towns Marty. This modem was bundled with the ...
The Miniature Card is 37 × 45 × 3.5 mm thick and can have devices on both sides of the substrate. Its 60-pin connector was a memory-only subset of PCMCIA and featured 16-bit data and 24-bit address bus with 3.3 or 5-volt signaling. Miniature Cards support Attribute Information Structure (AIS) in the I²C identification EEPROM.
The device includes a CR2032 lithium coin cell for memory backup when the two AA main batteries run out. For mass storage, HP 95LX has a single PCMCIA slot which can hold a static RAM card with its own CR2025 back-up coin cell.