Search results
Results From The WOW.Com Content Network
A deaerator plant. A deaerator is a device that is used for the removal of dissolved gases like oxygen from a liquid. Thermal deaerators are commonly used to remove dissolved gases in feedwater for steam-generating boilers. The deaerator is part of the feedwater heating system.
The spray type deaerator is similar to the tray type deaerator. The water is sprayed into a steam atmosphere and most of the oxygen and non-condensables are released to the steam. The water then falls to the steam scrubber where the slight pressure loss causes the water to flash a little bit which also aids the removal of oxygen and non ...
The steam heats the water in the tank; The water in the tank serves as a surge volume within the steam plant. The deaerating feed tank's surge volume allows the ship to change "bells" (steam turbine power output) and change the ship's speed without running the feed pump dry or flooding the turbines with liquid water.
Boiler water is liquid water within a boiler, or in associated piping, pumps and other equipment, that is intended for evaporation into steam.The term may also be applied to raw water intended for use in boilers, treated boiler feedwater, steam condensate being returned to a boiler, or boiler blowdown being removed from a boiler.
"Common injection points are just after the condensate polisher and again at the deaerator outlet." [ 1 ] This forms a thicker protective layer of hematite (Fe 2 O 3 ) on top of the magnetite. This is a denser, flatter film (vs. the undulation scale with OT) so that there is less resistance to water flow compared to AVT. [ 2 ]
The fuel consumption required to generate superheated steam is greater than that required to generate an equivalent volume of saturated steam. However, the overall energy efficiency of the steam plant (the combination of boiler, superheater, piping and machinery) generally will be improved enough to more than offset the increased fuel consumption.
A Rankine cycle with two steam turbines and a single open feedwater heater. A feedwater heater is a power plant component used to pre-heat water delivered to a steam generating boiler. [1] [2] [3] Preheating the feedwater reduces the irreversibilities involved in steam generation and therefore improves the thermodynamic efficiency of the system ...
A means had to be provided, of course, to put the initial charge of water into the boiler (before steam power was available to operate the steam-powered feedwater pump). The pump was often a positive displacement pump that had steam valves and cylinders at one end and feedwater cylinders at the other end; no crankshaft was required.