Search results
Results From The WOW.Com Content Network
The counter balance shafts have eccentric weights and rotate in opposite direction to each other, which generates a net vertical force. The balance shaft was invented and patented by British engineer Frederick W. Lanchester in 1907. [1] [2] It is most commonly used in inline-four and V6 engines used in automobiles and motorcycles.
Eccentric bottom bracket on a Burley tandem bicycle held in place with two set screws. The term is also used to refer to the device often used on tandem bicycles with timing chains, single-speed bicycles with a rear disc brake or an internal-geared hub, or any bicycle with vertical dropouts and no derailleur, to allow slight repositioning, fore and aft, of a bottom bracket to properly tension ...
The inner shaft is a moving part with an eccentric lobe for the inner rotor to spin around. The rotor spins around its center and around the axis of the eccentric shaft in a hula hoop fashion, resulting in the rotor making one complete revolution for every three revolutions of the eccentric shaft.
Self-aligning ball bearings, such as the Wingqvist bearing shown in the picture, are constructed with the inner ring and ball assembly contained within an outer ring that has a spherical raceway. This construction allows the bearing to tolerate a small angular misalignment resulting from shaft or housing deflections or improper mounting.
The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting rods. [4] A flywheel is often attached to one end of the crankshaft, in order to smoothen the power delivery and reduce ...
The eccentric shaft, whose position is controlled by the DME using an electric motor, rotates through a range of 225 degrees to push the intermediate arm towards, or away from, the camshaft. For lesser lift, the eccentric shaft moves the intermediate arm away from the camshaft, so that lesser of the camshaft profile is pressing on the ...
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion. The perimeter of this disc is geared to a stationary ring gear and has a series of output shaft pins or rollers placed through the face of the disc. These output shaft pins directly drive the output shaft as the cycloidal disc ...