Ads
related to: pcb test coupon design
Search results
Results From The WOW.Com Content Network
A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...
This is called electrical test or PCB e-test. A short is a connection between two points that should not be connected. An open is a missing connection between points that should be connected. [citation needed] For high-volume testing, a rigid needle adapter makes contact with copper lands on the board. [25]
PCB-Investigator is a software tool used for the analysis, visualization, and optimization of printed circuit boards (PCBs). It is used for tasks such as PCB design validation and quality assurance. It is developed by EasyLogix [1] owned by Schindler & Schill GmbH, a German company specializing in electronic design automation (EDA) software.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
The resist material protects the copper from dissolution into the etching solution. The etched board is then cleaned. A PCB design can be mass-reproduced in a way similar to the way photographs can be mass-duplicated from film negatives using a photographic printer. FR-4 glass epoxy is the most common insulating substrate.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.