Ads
related to: body sway in motion bar for trailer wheels and rims parts
Search results
Results From The WOW.Com Content Network
An anti-roll bar (roll bar, anti-sway bar, sway bar, stabilizer bar) is an automobile suspension part that helps reduce the body roll of a vehicle during fast cornering or over road irregularities. It links opposite front or rear wheels to a torsion spring using short lever arms for anchors.
One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, the torsion key, mounted perpendicular to the bar, that is attached to a suspension arm, a spindle, or the axle. Vertical motion of the wheel causes the bar to twist around its axis and is resisted by the bar's torsion resistance. The ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle. Radius rods are ...
Anti-roll bars are suspension components designed to mitigate body roll. They do this by connecting the wheels at either end of an axle with a torsion bar attached to the vehicle body. Body roll can also be reduced by lowering centre of mass of the vehicle body, fitting stiffer suspension springs and reducing the sprung mass of the vehicle. [4]
Mounted with the vehicle suspension stabilizer bars, each reduction mechanism houses a wave generator, flexible gear, and circular gear. [4] The system is activated when the vehicle enters a high-speed turn, and the sensors register vertical, longitudinal, and transverse forces which contribute to body lean and additional movements.
The bushing in line with the wheel can be kept relatively stiff to effectively handle cornering loads while the off-line joint can be softer to allow the wheel to recess under fore-aft impact loads. For a rear suspension, a pair of joints can be used at both ends of the arm, making them more H-shaped in plan view.