Search results
Results From The WOW.Com Content Network
An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. [1] It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter Bauman. [1]
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
The SAE J2716 SENT (Single Edge Nibble Transmission) protocol [1] is a point-to-point scheme for transmitting signal values from a sensor to a vehicle controller. It is intended to allow for transmission of high resolution data with a low system cost.
Temperatures are recorded along the optical sensor cable, thus not at points, but as a continuous profile. A high accuracy of temperature determination is achieved over great distances. Typically the DTS systems can locate the temperature to a spatial resolution of 1 m with accuracy to within ±1 °C at a resolution of 0.01 °C.
Exhaust Gas Temperature Sensor 99: 153: 9 Exhaust Gas Temperature Sensor 9A: 154: 6 Hybrid/EV Vehicle System Data, Battery, Voltage 9B: 155: 4 Diesel Exhaust Fluid Sensor Data % 9C: 156: 17 O2 Sensor Data 9D: 157: 4 Engine Fuel Rate g/s 9E: 158: 2 Engine Exhaust Flow Rate kg/h 9F: 159: 9 Fuel System Percentage Use A0: 160: 4
Larger-diameter platinum wire is used, which drives up the cost and results in a lower resistance for the probe (typically 25.5 Ω). UPRTs have a wide temperature range (−200 °C to 1000 °C) and are approximately accurate to ±0.001 °C over the temperature range. UPRTs are only appropriate for laboratory use.
Thermopiles are used to provide an output in response to temperature as part of a temperature measuring device, such as the infrared thermometers widely used by medical professionals to measure body temperature, or in thermal accelerometers to measure the temperature profile inside the sealed cavity of the sensor. [4]
Keep the temperature of the sensor wire constant and measure the voltage as a function of pressure; Note that keeping the temperature constant implies that the end losses (4.) and the thermal radiation losses (3.) are constant. [3] The electrical resistance of a wire varies with its temperature, so the resistance indicates the temperature of wire.