Search results
Results From The WOW.Com Content Network
Homebrew is an amateur radio slang term for home-built, noncommercial radio equipment. [1] Design and construction of equipment from first principles is valued by amateur radio hobbyists, known as "hams", for educational value, and to allow experimentation and development of techniques or levels of performance not readily available as commercial products.
The transceiver can transmit and receive on the HF 10-, 15-, 20-, 40-, 80- and 160-meter bands, [33] and can receive WWV and WWVH on 15 MHz. It can use SSB , FSK and CW on all bands. [ 33 ] The TS-820S' power consumption is 57 watts (with heaters on) when receiving and 292 watts when transmitting.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
In electronics, motorboating is a type of low frequency parasitic oscillation (unwanted cyclic variation of the output voltage) that sometimes occurs in audio and radio equipment and often manifests itself as a sound similar to an idling motorboat engine, a "put-put-put", in audio output from speakers or earphones.
These problems have the same cause: a regenerative receiver's gain is greatest when it operates on the verge of oscillation, and in that condition, the circuit behaves chaotically. [ 28 ] [ 29 ] [ 30 ] Simple regenerative receivers electrically couple the antenna to the detector tuned circuit, resulting in the electrical characteristics of the ...
The PRC-160 is the manpack HF radio for the Harris Falcon III family of radios. It replaces the earlier AN/PRC-150 , with a smaller form factor and lighter weight than its predecessor, and being capable of 4th Generation Automatic Link Establishment (4G ALE), achieving data transmission speeds up to 10 times faster.
The GU-50 (Russian: ГУ-50) is a power pentode vacuum tube intended for 50 watt operation as a linear RF amplifier on frequencies up to 120 MHz. It is, in fact, a Soviet-produced copy of the Telefunken LS-50 power pentode, [ 1 ] possibly reverse-engineered from German ( Wehrmacht ) military radios captured during World War II , or based on ...
In electronics engineering, frequency compensation is a technique used in amplifiers, and especially in amplifiers employing negative feedback.It usually has two primary goals: To avoid the unintentional creation of positive feedback, which will cause the amplifier to oscillate, and to control overshoot and ringing in the amplifier's step response.