Search results
Results From The WOW.Com Content Network
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
A symmetric layout of Charlieplexed LEDs. On left, 3 pins drive 6 LEDs arranged in a triangle. On right, 4 pins drive 12 LEDs arranged in a tetrahedron.. The Charlieplexing configuration may be viewed as a directed graph, where the drive pins are vertices and the LEDs are directed edges; there is an outward-pointing edge connected from each vertex to each other vertex, hence with n drive pins ...
A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions. Some GPIOs have 5 V tolerant inputs: even when the device has a low supply voltage (such as 2 V), the device can accept 5 V without damage.
NodeMCU was created shortly after the ESP8266 came out. On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [13]
These mappings allow a choice between closest possible color matching, and remapping the entire color range to allow for different gamuts. The reference illuminant of the Profile connection space (PCS) is a 16-bit fractional approximation of D50 ; [ 4 ] its white point is XYZ=(0.9642, 1.000, 0.8249).
Includes 14 color-coded 3-pin connectors for direct cable connection of servos, electronic bricks, etc., and 6 color-coded3-pin connectors to Analog inputs for electronic bricks, etc. Provides improved 3.3 V regulator supplying 500 mA, and optional 3.3 V operation. Switching regulator provides 5 V 2 A from up to 20 V external supply.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
Up to 4 pins may be required for implementing a JTAG standard interface. In general, modern protocols try to keep the number of pins used low, typically to 2 pins. Some ISP interfaces manage to achieve the same with just a single pin. Newer ATtiny microcontrollers with UPDI can even reuse that programming pin also as a general-purpose input ...