Search results
Results From The WOW.Com Content Network
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions. Some GPIOs have 5 V tolerant inputs: even when the device has a low supply voltage (such as 2 V), the device can accept 5 V without damage.
A symmetric layout of Charlieplexed LEDs. On left, 3 pins drive 6 LEDs arranged in a triangle. On right, 4 pins drive 12 LEDs arranged in a tetrahedron.. The Charlieplexing configuration may be viewed as a directed graph, where the drive pins are vertices and the LEDs are directed edges; there is an outward-pointing edge connected from each vertex to each other vertex, hence with n drive pins ...
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
It is common for different devices to use SPI communications with different lengths, as, for example, when SPI is used to access an IC's scan chain by issuing a command word of one size (perhaps 32 bits) and then getting a response of a different size (perhaps 153 bits, one for each pin in that scan chain).
NodeMCU was created shortly after the ESP8266 came out. On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [13]
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
The OP-code is usually the first 8 bits input to the serial input pin of the EEPROM device (or with most I²C devices, is implicit); followed by 8 to 24 bits of addressing, depending on the depth of the device, then the read or write data. Each EEPROM device typically has its own set of OP-code instructions mapped to different functions.