Ad
related to: sidewall vent caps for electrical wire ends
Search results
Results From The WOW.Com Content Network
Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.
Certain types of cable glands may also serve to prevent entry of flammable gas into equipment enclosures, for electrical equipment in hazardous areas. Although cable glands are often called "connectors", a technical distinction can be made in the terminology, which differentiates them from quick-disconnect, conducting electrical connectors.
A three phase electric circuit terminated with a pothead Crossarms with two three phase electric circuits terminated with potheads. A pothead is a type of insulated electrical terminal used for transitioning between overhead line and underground high-voltage cable or for connecting overhead wiring to equipment like transformers. [1]
Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation may be ...
Ring style wire-end crimp connectors. The connectors in the top row of the image are known as ring terminals and spade terminals (sometimes called fork or split ring terminals). Electrical contact is made by the flat surface of the ring or spade, while mechanically they are attached by passing a screw or bolt through them.
At a building the wires enter a conduit, a protective metal pipe, and the weatherhead is a waterproof cap on the end of the conduit that allows the wires to enter without letting in water. It is shaped like a hood , with the surface where the wires enter facing down at an angle of at least 45°, to shield it from precipitation.
Less commonly, a terminator is also placed at the driving end of the wire or cable, if not already part of the signal-generating equipment. [1] Radio frequency currents tend to reflect from discontinuities in the cable, such as connectors and joints, and travel back down the cable toward the source, causing interference as primary reflections ...
Two ribbon cables: the grey cable is stripped, and the rainbow cable has an IDC connector Connector blades IDC D-sub connectors DE-9 (male) and DA-15 (female) Connector blades cut insulation into the ribbon cable Australian (dual) power outlet, utilizing insulation displacement to connect mains voltage (230 V) supply conductors