Search results
Results From The WOW.Com Content Network
Hydrogen peroxide is a chemical compound with the formula H 2 O 2.In its pure form, it is a very pale blue [5] liquid that is slightly more viscous than water.It is used as an oxidizer, bleaching agent, and antiseptic, usually as a dilute solution (3%–6% by weight) in water for consumer use and in higher concentrations for industrial use.
This is achieved by the action of bleach activators, such as tetraacetylethylenediamine and sodium nonanoyloxybenzenesulfonate, upon hydrogen peroxide formed from sodium percarbonate in water. The peracetic acid is a more effective bleaching agent than hydrogen peroxide itself. [4] [5] PAA is also formed naturally in the environment through a ...
Hydrogen peroxide (H 2 O 2) can be used as HOCl scavenger whose byproducts do not interfere in the Pinnick oxidation reaction: HOCl + H 2 O 2 → HCl + O 2 + H 2 O. In a weakly acidic condition, fairly concentrated (35%) H 2 O 2 solution undergoes a rapid oxidative reaction with no competitive reduction reaction of HClO 2 to form HOCl. HClO 2 ...
An aqueous solution containing 2 g of glucose and 2 g of fructose per 100 g of solution contains 2/100=2% glucose on a wet basis, but 2/4=50% glucose on a dry basis.If the solution had contained 2 g of glucose and 3 g of fructose, it would still have contained 2% glucose on a wet basis, but only 2/5=40% glucose on a dry basis.
The heat of dilution can be defined from two perspectives: the differential heat and the integral heat. The differential heat of dilution is viewed on a micro scale, which is associated with the process in which a small amount of solvent is added to a large quantity of solution. The molar differential heat of dilution is thus defined as the enthalpy
Hydrogen peroxide works best as a propellant in extremely high concentrations (roughly over 70%). Although any concentration of peroxide will generate some hot gas (oxygen plus some steam), at concentrations above approximately 67%, the heat of decomposing hydrogen peroxide becomes large enough to completely vaporize all the liquid at standard pressure.
VHP is produced from a solution of liquid H 2 O 2 and water, by generators specifically designed for the purpose. These generators initially dehumidify the ambient air, then produce VHP by passing aqueous hydrogen peroxide over a vaporizer, and circulate the vapor at a programmed concentration in the air, typically from 140 ppm to 1400 ppm, depending on the infectious agent to be cleared. [6]
Baumé degrees (light) was calibrated with 0 °Bé (light) being the density of 10% NaCl in water by mass and 10 °Bé (light) set to the density of water. Consider, at near room temperature: +100 °Bé (specific gravity, 3.325) would be among the densest fluids known (except some liquid metals), such as diiodomethane .