Ad
related to: 1969 camaro rear end casting numbers chart free
Search results
Results From The WOW.Com Content Network
In 1969, it was used in almost all car lines—Camaros, Caprices, Impalas, El Caminos, Chevelles, and Novas. The 1969 L48s use a hydraulic cam, 4bbl Quadrajet carburetor, cast pistons, 4-bolt main casting number 010 blocks and casting number 041 or 186 heads. Power output was 300 hp (224 kW) SAE and 380 lb⋅ft (515 N⋅m) torque.
The only two vehicles to have been built using the F-Body platform are the Chevrolet Camaro and the Pontiac Firebird. The fourth character in the Vehicle Identification Number for an F-body car is "F" on model year 1985 and up vehicles. Earlier Camaros and Firebirds had differing VIN codes, but are now commonly referred to as F-bodies.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential ...
General Motors (GM) is an American car manufacturing company. It manufactures its own automobile transmissions and only purchases from suppliers in individual cases. They may be used in passenger cars and SUVs, or light commercial vehicles such as vans and light trucks.
It's New for '67! Chevrolet unveiled the Camaro in September 1966. The car carried a base price of $2,466 (about $22,043 today) and offered a wide range of options, including a choice of 15 ...
For premium support please call: 800-290-4726 more ways to reach us
It is widely accepted [citation needed] however that the minimum requirement for a vehicle to be Number matching (or matching numbers, depending on local terminology) is for the original Chassis number and/or Vehicle Identification Number (VIN) to match to the engine block, if that is how the original manufacturer identified it, and the data ...