Search results
Results From The WOW.Com Content Network
The projectile is a 20-gram, 15.2 mm fin-stabilized discarding-sabot type with armor-piercing capability which the IWS 2000 was specifically designed to fire only. It contains a dart-shaped penetrator of either tungsten carbide or depleted uranium , capable of piercing 40 mm [ 1 ] of rolled homogeneous armor at a range of 1,000 m, as well as ...
the new round uses a new sabot design, and a Tungsten Alloy penetrator of increased length compared to prior generation Russian APFSDS ammunition. Used on 2A46M-4/5 with new autoloader. Cartridge dimension: 735 mm [3] Penetrator dimension: 640 mm 28-29: 1 L/D; Round weight: ? kg; Projectile weight (including sabot): 8.4kg; Penetrator weight:
As a result, the twist rate of the larger barrel will dictate which smaller bullets can be fired with sufficient stability out of a sabot. In this example, using 1:10 rifling in 7.62mm restricts saboting to 5.56mm bullets that require 1:10 twist or slower, and this requirement will tend to restrict saboting to the shorter (and lighter) 5.56mm ...
The Raufoss Mk 211 is a .50 BMG (12.7×99mm NATO) multi-purpose anti-material high-explosive incendiary/armor-piercing ammunition projectile produced by Nammo under the model name NM140 MP. [1] It is commonly referred to as multipurpose or Raufoss , meaning red waterfall in Norwegian.
Armour piercing discarding sabot munitions were developed to increase penetrating performance of anti-tank projectiles by generating higher impact velocity.A larger projectile would require a completely new weapon system, but increasing velocity faced the limitation that steel armour-piercing (AP) projectiles shattered at velocities above about 850 m/s when uncapped.
The M829 is an American armor-piercing fin-stabilized discarding sabot kinetic energy penetrator tank round.Modeling was done at the Ballistic Research Laboratory at Aberdeen Proving Ground, [1] which was incorporated into the Army Research Laboratory in 1992.
It consists of a sub-caliber 0.224-inch (5.7 mm) diameter bullet, held in a .30-caliber 7-grain (0.45 g) six-fingered plastic sabot with a hollowed base. The bullet separates from the sabot approximately 14 inches (360 mm) from the muzzle.
Sub-caliber armour-piercing discarding sabot projectile. Here seen with and without its sabot as well as its internal tungsten core. The most traditional way to fire sub-caliber ammunition is to fit the projectile with an expendable sabot. The sabot is a device which fills out the missing caliber when the projectile is fired and then leaves the ...