Ads
related to: oil to gas conversion table calculator
Search results
Results From The WOW.Com Content Network
Oil conversion factor from m³ to bbl (or stb) is 6.28981100; Gas conversion factor from standard m³ to scf is 35.314666721; Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
When oil is produced to surface temperature and pressure it is usual for some natural gas to come out of solution. The gas/oil ratio (GOR) is the ratio of the volume of gas ("scf") that comes out of solution to the volume of oil — at standard conditions. In reservoir simulation gas/oil ratio is usually abbreviated .
Metric regions commonly use the tonne of oil equivalent (toe), or more often million toe (Mtoe). Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
Crude oil is classified as light, medium, or heavy according to its measured API gravity. Light crude oil has an API gravity higher than 31.1° (i.e., less than 870 kg/m 3) Medium oil has an API gravity between 22.3 and 31.1° (i.e., 870 to 920 kg/m 3) Heavy crude oil has an API gravity below 22.3° (i.e., 920 to 1000 kg/m 3)
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]
A 1 inch tall uranium fuel pellet is equivalent to about 1 ton of coal, 120 gallons of crude oil, or 17,000 cubic feet of natural gas. [15] In light-water reactors , 1 kg of natural uranium – following a corresponding enrichment and used for power generation– is equivalent to the energy content of nearly 10,000 kg of mineral oil or 14,000 ...
The tonne of oil equivalent (toe) is a unit of energy defined as the amount of energy released by burning one tonne of crude oil.It is approximately 42 gigajoules or 11.630 megawatt-hours, although as different crude oils have different calorific values, the exact value is defined by convention; several slightly different definitions exist.
Celsius heat unit (International Table) CHU IT: ≡ 1 BTU IT × 1 K/°R = 1.899 100 534 716 × 10 3 J: cubic centimetre of atmosphere; standard cubic centimetre: cc atm; scc ≡ 1 atm × 1 cm 3 = 0.101 325 J: cubic foot of atmosphere; standard cubic foot: cu ft atm; scf ≡ 1 atm × 1 ft 3 = 2.869 204 480 9344 × 10 3 J: cubic foot of natural ...