When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   One of the most common ways to produce such threaded holes is to drill a hole of appropriate size with a drill bit and then tap it with a tap. Each standard size of female screw thread has one or several corresponding drill bit sizes that are within the range of appropriate size—slightly larger than the minor diameter of the mating male ...

3. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   From top: Spade, brad point, masonry, and twist drills bits Drill bit (upper left), mounted on a pistol-grip electric drill A set of masonry drills. A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create different kinds of ...

4. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Fractional drill bit set by Craftsman. Fractional-inch drill bit sizes are still in common use in the United States and in any factory (around the globe) that makes inch-sized products for the U.S. market. ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments.

5. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   One advantage over the Phillips drive is that one driver or bit fits all screw sizes. It is often found in marine hardware and requires a Frearson screwdriver or bit to work properly. The tool recess is a perfect, sharp cross, allowing for higher applied torque, unlike the rounded, tapered Phillips head, which can cam out at high torque. It was ...

6. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   A set of "secure" or otherwise less common screwdriver bits, including secure Torx and secure hex or "Allen" variants. Many modern electrical appliances, if they contain screws, use screws with heads other than the typical slotted or Phillips styles. Torx is one such pattern that has become widespread. It is a spline tip with a corresponding ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   Two screws in the stock bear in to indentations on either side of the slit, tending to squeeze the slit closed, whilst a third screw with a tapered tip screws in to the slit forcing it open. Working these three screws against each other adjusts the die. Integrated screws appear to be common in the US but are almost unknown in the UK and Europe.