Search results
Results From The WOW.Com Content Network
In the single-piston designs, the engine captures the heat lost from the four-stroke Otto cycle or Diesel cycle and uses it to drive an additional power and exhaust stroke of the piston in the same cylinder in an attempt to improve fuel efficiency and assist with engine cooling. The pistons in this type of six-stroke engine go up and down three ...
The cycle is closed by the exhaust (4-0 and colored blue) stroke, characterized by isochoric cooling and isobaric compression processes. Temperature-Entropy diagram An Otto cycle is an idealized thermodynamic cycle that describes the functioning of a typical spark ignition piston engine .
The 301.6-cubic-inch (4.9 L) GMC inline six was produced from 1952 to 1960, when it was replaced by the V6. It has a square bore/stroke ratio of 4 by 4 inches (101.6 mm × 101.6 mm). This is the largest raised-deck engine. It was originally designed for the GMC military M135 and M211.
The 1906–1908 Ford Model K luxury car used a 405 cu in (6.6 L) straight-six petrol engine and was the only Ford six-cylinder passenger car engine until the 1940s. The Ford flathead I6 was produced from 1941 until 1951, followed by the Ford OHV I6 overhead valve engine from 1952 through 1964, then the Ford Thriftpower Six overhead valve engine ...
The Series 92 engines were introduced in 1974. [8] Compared to the Series 71 engines they were derived from, the Series 92 featured a larger bore of 4.84025 ± 0.00125 in (122.942 ± 0.032 mm) and an identical stroke of 5 in (130 mm) for a nominal displacement per cylinder of 92 cu in (1,510 cc), from which the Series 92 derives its name.
A boxer-style flat-six engine is able to have perfect primary and secondary balance.As in other six-cylinder engines, the overlapping of the power strokes of the different cylinders (with a firing interval of 120 degrees in a four-stroke engine) reduces the pulsating of the power delivery relative to that of similar engines with fewer cylinders.
Bore and stroke size is 3.552 in × 4.165 in (90.2 mm × 105.8 mm), identical to the 5.4 L V8. Both 2-valve and 3-valve versions have been produced. The 6.8 L uses a split-pin crank with 72° firing intervals and a balance shaft gear driven by the left camshaft to quell vibrations inherent to a 90° bank angle V10 engine. The engine's firing ...
Since there is no room in the V between the cylinder banks for an intake system, all the intakes are on one side of the engine, and all the exhausts are on the other side. It uses a firing order of 1-5-3-6-2-4 (which is the firing order used by most straight-six engines), rather than the common V6 firing order of 1-2-3-4-5-6 or 1-6-5-4-3-2.