Search results
Results From The WOW.Com Content Network
It is also useful to show the relationship between section lift coefficient and drag coefficient. The section lift coefficient is based on two-dimensional flow over a wing of infinite span and non-varying cross-section so the lift is independent of spanwise effects and is defined in terms of ′, the lift force per unit span of the wing. The ...
The subscript digit gives the range of lift coefficient in tenths above and below the design lift coefficient in which favorable pressure gradients exist on both surfaces. A hyphen. One digit describing the design lift coefficient in tenths. Two digits describing the maximum thickness as percent of chord.
The rates of change of lift and drag with angle of attack (AoA) are called respectively the lift and drag coefficients C L and C D. The varying ratio of lift to drag with AoA is often plotted in terms of these coefficients. For any given value of lift, the AoA varies with speed. Graphs of C L and C D vs. speed are referred to as drag curves ...
The number of vortices used vary with the required pressure distribution resolution, and with required accuracy in the computed aerodynamic coefficients. A typical number of vortices would be around 100 for an entire aircraft wing; an Aeronautical Research Council report by Falkner published in 1949 mentions the use of an "84-vortex lattice ...
The significant aerodynamic properties of aircraft wings are summarised by two dimensionless quantities, the lift and drag coefficients C L and C D. Like other such aerodynamic quantities, they are functions only of the angle of attack α, the Reynolds number R e and the Mach number M. C L and C D can be plotted against α, or can be plotted ...
Under these conditions, drag and lift coefficient are functions depending exclusively on the angle of attack of the body and Mach and Reynolds numbers. Aerodynamic efficiency, defined as the relation between lift and drag coefficients, will depend on those parameters as well.
The coefficient of lift for a two-dimensional airfoil section with strictly horizontal surfaces can be calculated from the coefficient of pressure distribution by integration, or calculating the area between the lines on the distribution. This expression is not suitable for direct numeric integration using the panel method of lift approximation ...
Lift is proportional to the density of the air and approximately proportional to the square of the flow speed. Lift also depends on the size of the wing, being generally proportional to the wing's area projected in the lift direction. In calculations it is convenient to quantify lift in terms of a lift coefficient based on these factors.