Ad
related to: how many yards per meter in one hour of water to gallons needed
Search results
Results From The WOW.Com Content Network
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
The amount of water that can be discharged through a conduit per second in a cubic foot is described as a cusec. In agriculture, a rough estimate by irrigation experts is that 1 TMC water is needed each year to irrigate 10,000 acres.
[13] [14] The total water extraction from center-pivot irrigation in the area is estimated to be about 5.42 million acre-feet of water per year. [15] In 1950, irrigated cropland covered 100,000 hectares (250,000 acres). With the use of center-pivot irrigation, nearly 1.2 million hectares (3 million acres) of land were irrigated in Kansas alone.
The term "second" comes from "the second minute division of an hour", as it is 1 ⁄ 60 of a minute, or 1 ⁄ 60 of 1 ⁄ 60 of an hour. While usually sub-second units are represented with SI prefixes on the second (e.g. milliseconds ), this system can be extrapolated further, such that a "Third" would mean 1 ⁄ 60 of a second (16.7 ...
In hydrology, discharge is the volumetric flow rate (volume per time, in units of m 3 /h or ft 3 /h) of a stream. It equals the product of average flow velocity (with dimension of length per time, in m/h or ft/h) and the cross-sectional area (in m 2 or ft 2). [1] It includes any suspended solids (e.g. sediment), dissolved chemicals like CaCO
A cubic yard (symbol yd 3) [1] is an Imperial / U.S. customary (non-SI non-metric) unit of volume, used in Canada and the United States. It is defined as the volume of a cube with sides of 1 yard (3 feet , 36 inches , 0.9144 meters ) in length .
All rivers with average discharge more than 15,000 cubic feet per second are listed. Estimates are approximate, because data are variable with time period measured and also because many rivers lack a gauging station near their point of outflow.
Municipal volumetric water measurements, including city water flow and cost per unit on a residential water bill, can either be measured in gallons, cubic feet, or cubic meters, with gallons being the most commonly used. Water bottles for personal use can have their capacity measured in fluid ounces or liters. For ounces, the measurements are ...