Search results
Results From The WOW.Com Content Network
Underdrive pulleys increase engine output by reducing the draw of the engine's accessories by slowing them down and reducing the horsepower (HP) they use. Horsepower gains from underdrive pulleys can vary by vehicle, engine, number of accessories and the amount of underdrive (improvements of up to 5–15 HP at the wheels have been seen).
If the car's own vapor recovery system is working properly, then the Stage II nozzle will only be vacuuming normal fresh air and depositing that into the gas station's underground fuel storage tanks. That ends up causing evaporation of fuel vapors into the atmosphere, because too much pressure builds up in those fuel storage tanks.
The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. [2] The pulleys consist of two cone-shaped halves that move together and apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pull
The reasons that the fuel pump is typically located in the fuel tank are: By submerging the pump in fuel at the bottom of the tank, the pump is cooled by the surrounding fuel; Liquid fuel by itself (i.e. without oxygen present) isn't flammable, therefore surrounding the fuel pump by fuel reduces the risk of fire; In-tank fuel pumps are often ...
The damper will be fitted at the front of the engine (opposite the clutch or transmission) just beyond the cover of the timing chain, gears, or belt, and behind the accessory drive pulley (which may carry one or more V, serpentine, or cogged belts.) In older vehicles the pulley and damper were separate units that were bolted together.
The National Highway Traffic Safety Administration is investigating reports of alleged engine failures in GM's 6.2-liter L87 V-8, an engine used in a wide variety of trucks and SUVs.
Plunger pumps have been used in the past, but these are now only used rarely, for small engines. To avoid the need for priming, the pump is always mounted low-down, either submerged or around the level of the oil in the sump. A short pick-up pipe with a simple wire-mesh strainer reaches to the bottom of the sump.
A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.