Ad
related to: clutch pedal has no pressure and does not pushjbugs.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
The clutch pedal controls the pressure plate (clutch engaged – the clutch pedal is not being pressed) or not connected to the engine (clutch disengaged – the clutch pedal is being pressed down). When the engine is running and the clutch is engaged (i.e., clutch pedal up), the flywheel spins the clutch pressure plate and hence the transmission.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
It also prevents wear on the brake or clutch pedal because even if no additional pressure is put on these pedals, the constant contact and abrasion of the driver's foot will wear away at the surface of pedals. In automatic cars, the dead pedal is normally just a rubber step placed on the floor of the car.
In a pull-type clutch, pressing the pedal pulls the release bearing to disengage the clutch. In a push-type clutch, pressing the pedal pushes the release bearing to disengage the clutch. A multi-plate clutch consists of several friction plates arranged concentrically. In some cases, it is used instead of a larger diameter clutch.
Semi-automatic transmissions are mechanically the same as a conventional manual transmission, but do not have a manually-operated clutch mechanism; instead facilitating the driver, by using automation system to control the clutch. These systems still require the driver's input and involvement for manually changing gear ratios, though, and will ...
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
A disadvantage of this arrangement is that there is no oil pressure to operate the transmission when the engine is not running, therefore it is not possible to push start a vehicle equipped with an automatic transmission with no rear pump (aside from several automatics built prior to 1970, which also included a rear pump for towing and push ...