Ads
related to: xy vise for drill press
Search results
Results From The WOW.Com Content Network
Column drill press is a common type characterized by the fact that the drill spindle can be moved up and down axially ("along a column"), and has a height-adjustable table, usually adjustable via a rack and pinion. They often used with a vise holding the workpiece, and the vice is again clamped to the table. The vice has to be moved in order to ...
Cross vise, which can be adjusted using leadscrews in the X and Y axes; these are useful if many holes need to be drilled in the same workpiece using a drill press. Compare router table. Off-center vise; Angle vise, with two jaws closing against a right angle; Sine vise, which use gauge blocks to set up a highly accurate angle; Rotary vise ...
The most common use is to support work when it is in a vise or clamped to the machine bed. If a workpiece is too small to be machined in a vise without it being in contact with all three faces of the vice - parallels can be used either side to give clearance from the vise, and to give support from underneath to eliminate the workpiece being ...
Counterbores that are not related to a specific screw size are designed to accept a removable pilot, allowing any given counterbore size to be adapted to a variety of hole sizes. The pilot matters little when running the cutter in a milling setup where rigidity is assured and hole center location is already achieved via X-Y positioning.
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
Drill press; E. Epoxy granite; H. Hobbing; ... X-Y table This page was last edited on 11 February 2018, at 19:38 (UTC). Text is available under the Creative ...