Ad
related to: 6v tensor desk bulb holder adapter ebay
Search results
Results From The WOW.Com Content Network
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
A Tensor lamp is a trademarked brand of small high-intensity low-voltage desk lamp invented by Jay Monroe. [ 1 ] [ 2 ] The lamp was mainly popular during the 1960s and 1970s. [ 3 ] [ 4 ] The lamp was originally used by doctors and dentists, and later became more widely used. [ 5 ]
The miniature 12-volt DC automotive-type #93 lightbulb utilized by Tensor, Lampette, and other designers of similar products, are smaller than the standard household 110/220-volt AC incandescent light bulb but produced more lumens in a smaller area, so that the lamp bulbs burn out at an increased rate. While standard bulbs last around 1,000 ...
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Bulbs of this type are commonly used in automotive lighting and in low-voltage lighting used in landscape lighting. The bulb may have dual filaments, acting as both a low-wattage tail light or parking light and a higher-wattage brake light or turn signal. In this case, one has its contacts near the center of the base, and the other toward the ...
or fixed to holder 1 14 V / 3.78W Used on circuit boards for e.g. dash lights, gauge cluster backlights. Similar in size to W3W if with a T10 base. PC74 T1-3/4 (if removable) or fixed to holder [9] 1 14 V / 1.4W Used on circuit boards for e.g. dash lights, gauge cluster backlights.
230/240-volt incandescent light bulb with E27 screw baseEdison screw (ES) is a standard lightbulb socket for electric light bulbs. It was developed by Thomas Edison (1847–1931), patented in 1881, [1] and was licensed in 1909 under General Electric's Mazda trademark.
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...