Ads
related to: jeep transfer case skid plate boltsamazon.com has been visited by 1M+ users in the past month
powertrainproducts.net has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The Dana 18 is a gear driven part-time transfer case. [2] Both the front and rear output shafts are offset towards the passenger side of the vehicle. Drive modes offered include 2-wheel high, part-time 4-wheel high, and part-time 4-wheel Low. All Dana 18 cases are cast iron and use the "Texas" bolt pattern with five bolts holding on the ...
The transfer case has no center differential, so power can only be supplied to the front axle when the rear wheels begin to slip. In this way, the transfer case works almost identically to the NV247 transfer case used in the Quadra-Trac II system in 1999 to 2004 WJ Jeep Grand Cherokees.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
The 1969 Universal offered a "462" performance package. It was a limited-production model that featured the V6 engine, front bucket seats and a rear bench, roll bar, heavy-duty frame and springs, a locking differential, oil-pan skid plate, rear swing-out tire carrier, full wheel covers, ammeter, and oil pressure gauges; padded visors were optional.
Retrofitted skid plate on a Saab 96. Fake skid plate. A skid plate is an abrasion-resistant material affixed to the underside of a vehicle or boat [1] to prevent damage to the underside when contact is made with the ground. Skid plates may be used on off-road vehicles, motorcycles and lowered vehicles to prevent damage to the underside. Fake ...
These bolts, usually tension control bolts or compressible washer tension indicating type bolts, are tensioned to a minimum required amount to generate large enough friction forces between the faying surfaces such that the shear (or tension) load is transferred by the structural members and not by the bolts (in shear) and the connection plates ...