When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Flex-Elektrowerkzeuge - Wikipedia

   en.wikipedia.org/wiki/Flex-Elektrowerkzeuge

   FLEX-Elektrowerkzeuge GmbH is a German producer of power tools with headquarters in Steinheim. Founded in 1922, after producing its first MS6 angle grinder , FLEX became the first supplier of the tool in 1935.

3. Flexible shaft - Wikipedia

   en.wikipedia.org/wiki/Flexible_shaft

   Flexible shaft tool. A flexible shaft, often referred to as a flex shaft, is a device for transmitting rotary motion between two objects which are not fixed relative to one another. It consists of a rotating wire rope or coil which is flexible but has some torsional stiffness. It may or may not have a covering, which also bends but does not rotate.

4. Bottom hole assembly - Wikipedia

   en.wikipedia.org/wiki/Bottom_hole_assembly

   Rotary assemblies [2] are commonly used where formations are predictable and the rig economics are an issue. In such an assembly the weight of the drill collars gives the BHA the tendency to sag or flex to the low side of the hole, collar stiffness length and stabiliser diameter and placement are engineered as a means of controlling the flex of the BHA.

5. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2 -inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8 -inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming ( S&D ) bits, whose sets run from 9 ⁄ 16 -inch (14 mm) to 1 + 1 ⁄ 2 -inch (38 mm) drill ...

6. Giubo - Wikipedia

   en.wikipedia.org/wiki/Giubo

   A driveshaft coupling. Note the split damage beginning to appear, likely due to the large axial displacement. A giubo. A giubo (/ ˈ dʒ uː b oʊ / JOO-boh; etymology: giunto Boschi, "Boschi joint"), also known as a 'flexdisc', and sometimes misspelled as guibo, is a flexible coupling used to transmit rotational torque between the drive shaft and the companion flange on mechanical devices ...

7. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.